Sylvania 40999 LED10T8L48FP830SUBG8

SYLVANIA Lamps
SubstiTUBE® IPS LED T8

Application
SubstiTUBE IPS LED T8 lamps are an energy saving alternative, designed to replace traditional fluorescent T8 lamps. These LED T8 lamps contain no mercury, provide instant light and a uniform light distribution.

Engineered to operate on existing instant start and select programmed rapid start electronic T8 ballasts, these lamps minimize labor and recycling costs. Because the SubstiTUBE IPS LED T8 is not affected by switching cycles, the use of occupancy or vacancy sensors can be installed with the existing instant start ballasts for optimal energy savings.

Benefits and Features

• Shatterproof Frosted Nano Plastic lamps do not break in the manner of glass LED or fluorescent lamps
• CCT: 3000K, 3500K, 4100K, 5000K
• Beam angle: 160°
• Light emitting area: 340°
• G13 medium bi-pin base
• No warm-up time, instant-on with full light output and stable lamp to lamp color
• No UV emission
• Suitable for dry and damp locations (cannot come in direct contact with water)
• Maximize energy savings with occupancy sensors
• Suitable for open and enclosed fixtures
• BAA (Buy American Act) COTS compliant models available

Electrical

• Compatible with instant start and select programmed rapid start electronic T8 ballasts with input voltage of 120-277V and 347V
• 10W and 13W 4-foot lamps are 0-10V dimmable with compatible 0-10V dimming ballast
• Power Factor >0.90
• THD <20%

Rated Life

• 50,000 hours (L70)

Ambient Operating Range

• -4°F to +104°F (-20°C to +40°C)

Warranty

• 5-year limited lamp warranty (24/7 operation)
• NLB Trusted Warranty Program

Certifications and Listings

• cULus
• RoHS
• Lead Free
• Mercury Free
• DLC 5.1
• NSF Listed: NSF/ANSI Standard 2 – Food Equipment

Application Information

1. Due to numerous ballast designs and topologies, this lamp should be tested on existing ballasts before mass quantities are installed.
2. Not intended for use with older dedicated voltage (120V or 277V) ballasts. These ballasts have electronic components that degrade over time and may become unsuitable for the new LED T8 lamp.
3. All installation, inspection, and maintenance of lighting fixtures should be done with the power to the fixture turned off. Lamps should be installed and operated in compliance with the National Electrical Code (NEC), Underwriters Laboratories Inc. (UL) requirements, and all applicable codes and regulations.
4. Insert and align tubes properly in lamp holders. Partial insertion results in a poor or intermittent electrical contact that can result in short lamp life and arcing. Arcing at the lamp holder can result in localized overheating.
5. For instant start ballasts, use lamp holders with an internal shunt or ensure that lamp holders are wired in a shunt configuration.
6. For Programmed Rapid Start ballasts, use rapid-start lamp holders (non-shunted lamp holders).
7. De-lamp is not allowed for ISH ballasts. For approved ISN and ISL ballasts, de-lamp is allowed for only 1 lamp so long as the ballast factor remains below 1.20 (for example, 4 lamp ballast can de-lamp to 3 lamps).
8. Operating temperature range between -4°F and 113°F (-20°C and 45°C).
9. Suitable for use in dry and damp environments.
10. Maximum mounting distance between tube and ballast is 20 feet.
11. Not for use with other LED or fluorescent lamps on the same ballast.
12. Not for use with magnetic ballasts.
13. Please read all installation instructions before attempting installation.
14. For detailed warranty information, please see www.ledvanceUS.com.